The DE23 plans call for a 20" shaft. I would like to us a 25" shaft. Is it just a matter of cutting the transom 5" higher?
I'm a little concerned with the 20" transom in following seas and with reverse gear in chop. Do you think my concern is worth the extra cost of a extra long shaft engine?
DE23 Transom Change
-
- Frequent Poster
- Posts: 35
- Joined: Sat Aug 24, 2002 1:00 am
- Location: Sydney, Nova Scotia, Canada
DE23 Transom Change
Glenn Langille
Sydney, Nova Scotia
Sydney, Nova Scotia
-
- Very Active Poster
- Posts: 725
- Joined: Thu Aug 22, 2002 1:00 am
- Location: MD
Re: DE23 Transom Change
YesGlenn wrote:Is it just a matter of cutting the transom 5" higher?
No. The motorwell bulkhead in front of the transom is the height of the uncut transom on Jacques' designs. Water entering the motorwell will drain out without getting into the rest of the boat.Glenn wrote:Do you think my concern is worth the extra cost of a extra long shaft engine?
Ralph
Who is online
Users browsing this forum: No registered users and 0 guests