re-finishing meranti table with EMC clear coat

technical support and information on EMC topcoats and coatings
ks8
* Bateau Builder *
* Bateau Builder *
Posts: 8408
Joined: Mon Nov 24, 2003 1:00 am
Location: NC USA
Location: Now a much longer sail to Tampa Florida! Back to NC, Youngsville FM05tw

Re: re-finishing meranti table with EMC clear coat

Post by ks8 »

:lol: Nice 8)

The new economy of the 21st century, summarized in *re-purposing*? I learned how to shift a motorcycle transmission beause of the motorcyle/lawnmower in East Germany just at the beginning of the re-unification. Else it would have been a slow-mow. :lol:

Looked something like this, except the back end was a dirt bike, around 150cc , and the *mower* attachment was more commercial hefty .... the motorcycle back end was heavy, and tough to keep it upright when going real slow, but it did cut the grass!

Image

Of course, it didn't look half as good as your new front door. 8)

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests