Draft on CS25

Power Boats only. Please include the boat type in your question.
Jwhitakeriii
Active Poster
Active Poster
Posts: 346
Joined: Sun Jun 10, 2018 10:31 pm
Location: Fort Valley Ga

Draft on CS25

Post by Jwhitakeriii »

I may have missed it on the study plans but does anyone know what the draft is as designed on the CS25?

Reid
Site Admin
Site Admin
Posts: 717
Joined: Wed Aug 03, 2016 12:34 pm
Location: Fort Pierce, FL

Re: Draft on CS25

Post by Reid »

Jwhitakeriii,

The CS25 is a self-bailing hull. Looking at the plans, the Base Line (BL) is set for the underside of the sole. This would also be the approximate location of the waterline. The measurement from the BL to the bottom of the transom is 15.25". That should give you a good estimate of the draft.

-Reid
Someone asked me, if I were stranded on a desert island what book would I bring... "How to Build a Boat."
- Steven Wright

Jwhitakeriii
Active Poster
Active Poster
Posts: 346
Joined: Sun Jun 10, 2018 10:31 pm
Location: Fort Valley Ga

Re: Draft on CS25

Post by Jwhitakeriii »

Thanks Reid. How is your build coming along?

Reid
Site Admin
Site Admin
Posts: 717
Joined: Wed Aug 03, 2016 12:34 pm
Location: Fort Pierce, FL

Re: Draft on CS25

Post by Reid »

FS18 is pretty much done. Just need to put a motor on, rig the electrical components, and get a poling platform made.
Someone asked me, if I were stranded on a desert island what book would I bring... "How to Build a Boat."
- Steven Wright

Post Reply

Who is online

Users browsing this forum: No registered users and 10 guests