Done! thanks ...will be out tomorrow back to youmajorgator wrote:tool placed in mail today to montuno/javier
please return when done...and good luck on getting that boat in the water
seth
Drain tube flaring tool
Re: Drain tube flaring tool
Javier
-
- * Bateau Builder *
- Posts: 1794
- Joined: Tue Apr 29, 2008 8:58 pm
- Location: High Springs, FL
Re: Drain tube flaring tool
OK, I've got the tool again. Still haven't used it, but will send to someone who needs it more than I.
seth
seth
Re: Drain tube flaring tool
Hi Seth,
Will be needing the flaring tool with a quick turnaround. could you e mail me for my address ?
Thank You.Jmbadge...
Will be needing the flaring tool with a quick turnaround. could you e mail me for my address ?
Thank You.Jmbadge...
1989 overnighter 2005 150 yamaha
-
- * Bateau Builder *
- Posts: 1794
- Joined: Tue Apr 29, 2008 8:58 pm
- Location: High Springs, FL
Re: Drain tube flaring tool
jmbadge -
send me an email with your address
sethgs0982 at gmail dot com
send me an email with your address
sethgs0982 at gmail dot com
-
- * Bateau Builder *
- Posts: 1794
- Joined: Tue Apr 29, 2008 8:58 pm
- Location: High Springs, FL
Re: Drain tube flaring tool
tool sent to jmbadge today...
Re: Drain tube flaring tool
Dang, much more shipping charges for you, you could have bought onemajorgator wrote:tool sent to jmbadge today...
Completed: FL14, OD18
-
- * Bateau Builder *
- Posts: 1794
- Joined: Tue Apr 29, 2008 8:58 pm
- Location: High Springs, FL
Re: Drain tube flaring tool
Yeah, tell me about it I don't want to break the seal on my large tube of 3M 5200 for two little drain holes, so I'll put this off a little while Plenty of other things to do on the XF to keep me busy though......much more shipping charges for you...
seth
Re: Drain tube flaring tool
I just bought the 1" and 1 1/4" moeller flange tool for $36.00 each. Thought it was a good deal. Just went to the site and they have raised the price in less than a week.
Edit: My bad, they are still 36 bucks
Edit: My bad, they are still 36 bucks
Completed: FL14, OD18
Re: Drain tube flaring tool
Got the tool about a week ago replaced the starboard side with no problem, the port side is a different story.I must have cranked to hard on the tool and a small crack developed in the brass tube. Its just on the outside rim though.What do you think guys should I redo the port tube or let it go for awhile.... Feedback welcome.. Thanks .. Jmbadge..
1989 overnighter 2005 150 yamaha
- Cracker Larry
- * Bateau Builder - Expert *
- Posts: 22491
- Joined: Fri Mar 11, 2005 3:39 pm
- Location: Savannah, GA
Re: Drain tube flaring tool
Who's got the flaring tool? I need it for a quick project. Thanks
Completed GF12 X 2, GF16, OD18, FS18, GF5, GF18, CL6
"Ships are the nearest things to dreams that hands have ever made." -Robert N. Rose
Who is online
Users browsing this forum: No registered users and 12 guests