The forum upgrade is complete. It was very uneventful. Please post issues in this thread.

Due to a high level of "bad actor" traffic on the community site Jaysen is implementing a forced verification to confirm that you are a human. This is a PITA and he hates it too. The 3.2 seconds it takes for the one time you have to do it every couple hours is much preferable to the hours we are losing to morons clogging the CPU on the servers. Jaysen is still looking to solve this a bit less intrusively and without cost to BBC. Hopefully the magic solution will appear out of thin air soon. Jaysen is already annoyed.

Buffing EMC topcoat

technical support and information on EMC topcoats and coatings
Post Reply
Boater45
* Bateau Builder *
* Bateau Builder *
Posts: 717
Joined: Thu Apr 09, 2009 9:09 am
Location: Broken Arrow, Oklahoma

Buffing EMC topcoat

Post by Boater45 »

Has anyone every buffed EMC Quantum topcoat? If so could you give me some dos and don'ts.


viewtopic.php?f=12&t=19337
OB17 - Will White, Broken Arrow, OK
Top
jacquesmm
Site Admin
Site Admin
Posts: 28215
Joined: Wed Aug 14, 2002 1:00 am
Location: Florida USA
Contact:
Contact jacquesmm

Re: Buffing EMC topcoat

Post by jacquesmm »

Yes, we did it here. There is nothing special to it: slow speed in order not to warm it up . . . we used Finesse buffing compound.
Jacques Mertens - Designer
http://boatbuildercentral.com
Top
Boater45
* Bateau Builder *
* Bateau Builder *
Posts: 717
Joined: Thu Apr 09, 2009 9:09 am
Location: Broken Arrow, Oklahoma

Re: Buffing EMC topcoat

Post by Boater45 »

Did you use a standard polisher with a foam pad?
viewtopic.php?f=12&t=19337
OB17 - Will White, Broken Arrow, OK
Top
Post Reply

Return to “EMC paints/coatings”

Who is online

Users browsing this forum: No registered users and 1 guest