Hey Guys,
Just wanted to keep Cracker Larrys tool exchange going.
I've got a set of flaring tools 1" and 1 1/4" that I'd like to put in the tool exchange. I'm not using them anymore and don't plan on building another boat, as much as I'd like to build another one, it's just not going to happen.
So if someone needs the tool just let me know and I'll ship it out to you, As Cracker Larry did, only cost to you is shipping to the next guy.
Hope this helps some builders.
Larry B
btw, Cracker Larry has used this set that I'm offering, I sent it to him awhile back when his was out being used by someone else.
Drain tube flaring tool
Drain tube flaring tool
Completed: FL14, OD18
Re: Drain tube flaring tool
Yes please! I will need one soon to flair mine. I was trying to decide if I wanted to buy one the other day to complete the job. And, I'll gladly ship it to the next person.
I'll send you a PM with my address.
Steve
I'll send you a PM with my address.
Steve
Re: Drain tube flaring tool
Steve,
I got your info, should go in the mail tomorrow
Larry B
I got your info, should go in the mail tomorrow
Larry B
Completed: FL14, OD18
Re: Drain tube flaring tool
Steve,
Flaring tools went out today, I'll send tracking info to you PM
Flaring tools went out today, I'll send tracking info to you PM
Completed: FL14, OD18
Re: Drain tube flaring tool
Excellent! Thank you very much! This site and the people on it are awesome!! I'll let everyone know when I'm done with them.
Re: Drain tube flaring tool
Dutch1, give me a call early next week and we can discuss BMS Jack Plates!! I am up in Saint Augustine tonight and most of tomorrow!! Jeff
- cape man
- * Bateau Builder - Expert *
- Posts: 8278
- Joined: Sun Jan 20, 2008 12:02 pm
- Location: Lithia, Florida
Re: Drain tube flaring tool
Pay it forward!
The world always seems brighter when you've just made something that wasn't there before - Neil Gaiman
-
- * Bateau Builder *
- Posts: 1202
- Joined: Sat Mar 16, 2013 10:25 am
- Location: Wels,Austria,Europe
Re: Drain tube flaring tool
I do not need such a tool but I am nosy how do you use it with all these washers next to some nuts ?
-
- * Bateau Builder - Expert *
- Posts: 8938
- Joined: Tue Aug 02, 2011 4:23 am
- Location: Kasilof, Alaska
Re: Drain tube flaring tool
Karl there is a "forcing cone" at each end. You have a stud, put a nut on it, place two washers on the stud and the the forcing cone. After you set your drain tube in place you run the stud through it install forcing cone, washers and nut. Tighten the nuts to flare the drain tube. Easier to do than explain
Re: Drain tube flaring tool
This explains it well. https://www.jamestowndistributors.com/u ... docId=1022
Who is online
Users browsing this forum: No registered users and 7 guests