Does anyone know anything about silicone moulds?
I am wondering if silicone can stand up to battery acid. My googles say yes.
I need to make some very close fitting moulds for the battery bottoms. Obviously, could be done with epoxy and glass.
The forum upgrade is complete. It was very uneventful. Please post issues in this thread.
Due to a high level of "bad actor" traffic on the community site Jaysen is implementing a forced verification to confirm that you are a human. This is a PITA and he hates it too. The 3.2 seconds it takes for the one time you have to do it every couple hours is much preferable to the hours we are losing to morons clogging the CPU on the servers. Jaysen is still looking to solve this a bit less intrusively and without cost to BBC. Hopefully the magic solution will appear out of thin air soon. Jaysen is already annoyed.
Due to a high level of "bad actor" traffic on the community site Jaysen is implementing a forced verification to confirm that you are a human. This is a PITA and he hates it too. The 3.2 seconds it takes for the one time you have to do it every couple hours is much preferable to the hours we are losing to morons clogging the CPU on the servers. Jaysen is still looking to solve this a bit less intrusively and without cost to BBC. Hopefully the magic solution will appear out of thin air soon. Jaysen is already annoyed.
Silicone moulding
-
fallguy1000
- * Bateau Builder - Expert *
- Posts: 9802
- Joined: Tue Jan 12, 2010 12:25 am
Who is online
Users browsing this forum: No registered users and 0 guests