The forum upgrade is complete. It was very uneventful. Please post issues in this thread.

Due to a high level of "bad actor" traffic on the community site Jaysen is implementing a forced verification to confirm that you are a human. This is a PITA and he hates it too. The 3.2 seconds it takes for the one time you have to do it every couple hours is much preferable to the hours we are losing to morons clogging the CPU on the servers. Jaysen is still looking to solve this a bit less intrusively and without cost to BBC. Hopefully the magic solution will appear out of thin air soon. Jaysen is already annoyed.

CMC Power Tilt and Trim bracket

Share tips, suggest or request changes, anything that does not fit in the other categories.
wpstarling
Frequent Poster
Frequent Poster
Posts: 97
Joined: Fri Mar 27, 2020 12:23 pm
Location: Crawfordville, FL

CMC Power Tilt and Trim bracket

Post by wpstarling »

I bought a jon boat recently that had one of these on it and I don't need it. It's a simple 2 wire system but the actuator/motor do not currently work when you wire to battery so it will need to be replaced.. They're about $80 from what I see online. A new unit is over $800, I'm asking $300. I can ship for the right deal but it will be expensive since it's large/heavy.

Not sure how to do pics but here is the Craigslist ad: https://tallahassee.craigslist.org/bpo/ ... 14974.html

I'm near Tallahassee, FL


Boats restored: 1973 Glastron CV16, 1990 Proline 17 CC, 1993 Bass Boat
Boats built: custom 15ft flat bottom skiff, Soon-to-be-built TX18 (originally dborecky's build)

Who is online

Users browsing this forum: Ahrefs [Bot] and 0 guests